SCX25AMP

Matched Pair of SCX25A Large Diaphragm Condensers

When you need accurate stereo microphones that are synced with each other, the SCX25AMP Matched Pair is the perfect set. Featuring two matched SCX25A microphones, you can rely on these microphones for any stereo field recording you can think of.

The SCX25A is a professional studio condenser microphone with an elegant design and a patented capsule suspension system. Uniquely shock-mounted within an intricate machined brass ring, the capsule is completely isolated from the mic body and electronics. By successfully minimizing acoustic reflections and diffractions, the SCX25A delivers a pure, open-air sound with exceptional detail and realism.

The SCX25A is consistent when responding to on and off-axis signals. This mic exhibits outstanding phase coherence and minimal proximity effect. With a wide cardioid polar pattern, the SCX25A enables the sound engineer to blend the sound of the instrument or vocal with the sound of the room. The SCX25A large diaphragm microphone will handle SPLs in excess of 135 dB and provides up to 20 dB of ambient noise rejection.

Affectionately referred to as “The Lollipop,” The SCX25A cardioid studio condenser microphone is perfectly suited to capture the sound of acoustic instruments such as pianos, guitars, vibes, woodwinds, brass, percussion toys, drums, orchestra, and symphony sections.

Designed, machined, assembled, and tested by Audix in the USA.


3 Interest-Free Payments Available with
for orders $199 and up. Learn more
Where To Buy SCX25AMP – Matched Pair of SCX25A Large Diaphragm Condensers
Transducer Type Condenser
Frequency Response 20 Hz – 20 kHz
Polar Pattern Cardioid
Output Impedance 200 ohms
Sensitivity 28 mV / Pa @ 1k
Equivalent Noise Level 14 dB (A-weighted)
Signal to Noise Ratio 80 dB
Maximum SPL ≥135 dB
Dynamic Range 121 dB
Power Requirements 48-52 V phantom
Connector 3-pin XLRm
Polarity Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
Materials / Finish Machined Brass / Black Finish
Weight 244 g / 8.6 oz
Length 148 mm / 5.8 in
Download Spec Sheet

2x SCX25A Matched Condenser Microphones
2x DCLIP Heavy-duty snap-on clip
1x Protective zippered carrying case

Capture.Share.

*Manufactured under licence